This will take about 4-6 minutes, depending on flashtype Only select NAND 1, bigblock, raw, differential flash with pages per block 64 and blockcount 1024 use zadig to change from winUSB to libUSB0.run in Compatibility mode for winxp SP2 + as Administrator.Use Progskeet 110819 as flasher software.Make sure the is on the Actel (lastest, if using clip).WinSkeet 111004: use preset + bank splitting Max bytes: (greyed out by single word program)
Ready triggered timing (fastest, default) NORway v0.4 beta 12: 'erasechip' and 'writewordubm' NOR pads are huge in comparison and easy to solder, plus the connection is stable. Soldered connection is still the highly adviced way to go. Writing will still fail, but at least it will now not burn out your motherboard or Progskeet (and perhaps can be used for dumping). 48 on clip 50ZIF = 3 on skeet 50ZIF = wpĤ6 on clip 50ZIF = 5 on skeet 50ZIF = gp2 therefore only needing to remove pin 48 cos thats also sending gp4 to gnd ie pin 46 goes to gnd so u could leave it NOR clip mod - flatcable header 48 goes to gnd and gp4 on skeet _: buy one from, if you don't mind wasting your money, and you, too, shall see that the 360-clip does not have the correct pinout when hooked up with the adapter board in between. Teensy++ 2.0 (dump, not write) : 918 seconds per NAND.Infectus (dump, not write) : 900 seconds per NAND.ChipProg‐G4 (write+verify) : 641 seconds.ChipProg‐48 (write+verify) : 641 seconds.Teensy++ 2.0 (diffwrite+verify) : 180 seconds per NAND.Progskeet 1.0/1.1 (dump, not write) : 158 seconds per NAND.BeeHive204AP (write+verify): 122.7 seconds per NAND.SuperPro 5000 (write+verify) :116.5 seconds per NAND.Flashstream 2800F (write+verify) : 34.7 seconds per NAND.ChipProg‐G41 (write+verify) : 23 seconds.ChipProg‐481 (write+verify) : 23 seconds.Samsung K9F1G08U0A flasher speeds, full write 1Gb: 20 NORway / Teensy experimental Samsung support.19.3 PCCard/Compact Flash, SRAM, PSRAM, NOR and NAND.16 Offboard flashing / Replacement NOR talk.13 Problematic Samsung / Spansion N related.5 Injecting 3.3V (or 5V/12V etc) with external PSU.
0 kommentar(er)
